Table of Contents
Advertisement
dellapd
dellapd
To delete an Link Access Protocol D channel (LAPD), use the dellapd command in the VoIP
switching/trunking operating mode.
Syntax Description
line-num
ds0-num
Command Modes
VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the D channel for line number 2, DS0 number 14 is deleted:
dellapd 2 14
Related Commands
Command
addlapd
dsplapd
dsplapds
Cisco VISM Installation and Configuration Guide
5-256
dellapd line-num ds0-num
Line number of the channel from which to delete an LAPD, in the range from 1 to 8.
DS0 number of the channel from which to delete an LAPD. It can be a value from one
of the following ranges:
1 to 24 for T1 lines
•
1 to 31 for E1 lines
•
Description
Adds an LAPD from a specified DS0 to a VISM card.
Displays data about an LAPD.
Displays data about all LAPDs.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
