Table of Contents
Advertisement
Chapter 5
CLI Commands
out-package
1. Dial pulse is not supported in VISM.
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
This command enables RFC 3064 support.
Examples
The following example shows that the MGCP packages for endpoint number 83 are configured with
mgcplin as the MGCP incoming package name and mgcplout as the MGCP outgoing package name:
cnfcaspackage 83 mgcp1in mgcp1out
Related Commands
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Package name to be used for persistent events observed on an outgoing
telephony call. It can be one of the following values:
•
MS = PBX DID/DOD trunks and incoming or outgoing MF wink start
trunks
•
DT = DTMF and dial pulse
•
MD = North American MF Feature Group D EANA and EAIN
•
MO = FGD Operator Services Signaling outgoing trunks only
BL = DTMF and dial pulse
•
L = Line
•
H = Handset
•
Basic = It can be from the following:
•
G—generic
–
–
D—DTMF
–
M—MF
–
T—Trunk
–
L—Line
H—Handset
–
R—RTP
–
A—Announcement Server
–
Script—Script
•
If you set the package to anything other than basic on an endpoint with
Note
this command, persistent events observed on that endpoint are encoded
as an event in that package if the event is defined in that package, or
dropped if they are not defined in that package. Packages N and S are
not supported.
1
trunks (except basic PBX)
1
basic PBX trunks
Cisco VISM Installation and Configuration Guide
cnfcaspackage
5-107
Advertisement
Table of Contents
