Table of Contents
Advertisement
Chapter 5
CLI Commands
dsprtpcon
To display the configuration data of a specified static Real-Time Transport Protocol (RTP) VoIP trunking
connection, use the dsprtpcon command in the VoIP switching/trunking and VoIP and switched ATM
AAL1 SVC operating modes.
Syntax Description
conn-num
Command Modes
VoIP switching/trunking and VoIP and switched ATM AAL1 SVC
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the configuration data for the static RTP connection number 106 is
displayed:
dsprtpcon 106
Connection Index
Endpoint Number
Local RTP Port
Remote RTP Port
Remote IP Address
Codec Type
Packetization Period :20
ECAN Status
VAD
VAD Timer
CAS Transport
DTMF Transport
ICS Enable
Triple redundancy
Bearer TOS
Connection Mode
Conn Alarm State
Related Commands
Command
addlapdtrunk
addrtpcon
addrudptrunk
clrrtpcnt
cnflapdtrunkpvc
cnflntrunkcond
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
dsprtpcon conn-num
Connection identification number. It can be in the range from 1 to 248.
:106
:200
:50000
:49650
:nnn.nnn.nnn.nnn
:G.729a
:Enable
:Enable
:300 ms
:On
:On
:On
:On
:160
:GW can send and recv packets
:
Description
Adds an LAPD trunk to a specific VISM card line.
Adds a static RTP VoIP trunking connection.
Adds an ISDN PRI backhaul RUDP session for an LAPD trunk connection.
Clears the RTP counters (statistics) for a specific static RTP connection.
Assigns the PVC trunk type that carries LAPD messages for the current VISM
card.
Enables or disables line conditioning on a VISM card line if a network alarm
is encountered.
Cisco VISM Installation and Configuration Guide
dsprtpcon
5-409
Advertisement
Table of Contents
