Cisco Voice Interworking Services (VISM) Installation And Configuration Manual page 574

dspsrcpcnts
dspsrcpcnts
To display the Simple Resource Control Protocol (SRCP) message counters (statistics) for all known call
agents, use the dspsrcpcnts command in the VoIP switching/trunking operating mode.
Syntax Description
This command has no arguments or keywords.
Command Modes VoIP switching/trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples The following example shows that the SRCP message counters (statistics) for all known call agents are
displayed:
dspsrcpcnts
Ip
-------
2.2.2.2
Related Commands Command
dspsrcpcnt
dspsrcppeer
dspsrcppeers
dspsrcpport
dspsrcpretry
Cisco VISM Installation and Configuration Guide
5-430
dspsrcpcnts
Name Discarded
-------- ---------
mgc1 0
Description
Displays the SRCP message counters (statistics) for a specified call agent.
Displays the peer configuration data for a specified SRCP peer (call agent).
Displays the peer configuration data for all known SRCP peers (call agents).
Displays the local UDP port number used by the SRCP on VISM.
Displays the card level SRCP retransmission parameters—maximum number of
retransmission attempts, minimum timeout, and maximum timeout.
Augw/Fail Auln/Fail Ntfy/Fail
--------- --------- ---------
0/0 0/0
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
Chapter 5
Rqnt/Fail
---------
0/0 0/0
CLI Commands