Table of Contents
Advertisement
dspcasparamsource
dspcasparamsource
To display the currently configured timer source parameters for channel associated signaling (CAS) of
a specified endpoint, use the dspcasparamsource command in the VoIP switching/trunking, switched
AAL2 PVC, and AAL2 trunking operating modes.
Syntax Description
endpt-num
Command Modes
VoIP switching/trunking, switched AAL2 PVC, and AAL2 trunking
Usage Guidelines
Follow standard CLI procedures for this command.
Examples
The following example shows that the CAS parameter source for endpoint number 1 is displayed:
dspcasparamsource 1
Ds0IfIndex:
CasParameterSource: MibValue
Related Commands
Command
cnfcasparamsource
Cisco VISM Installation and Configuration Guide
5-312
dspcasparamsource endpt-num
Endpoint number for which you want to display the CAS parameter source.
It can be a value from one of the following ranges:
•
For template number 1:
For template number 2:
•
•
For template number 3:
For template number 4:
•
1
Description
Configures an endpoint's CAS-related timer parameters source.
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
For VISM-PR E1, from 1 to 248
–
For VISM-PR, from 1 to 144
–
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands
Advertisement
Table of Contents
