cnfcasoffhooktime
cnfcasoffhooktime
To configure a minimum presence time, on an endpoint, for a CAS off-hook pattern to be recognized as
an off-hook signal, use the cnfcasoffhooktime command in the VoIP switching/trunking and switched
AAL2 PVC operating modes.
Syntax Description
endpt-num
offhooktime
Command Modes
VoIP switching/trunking and switched AAL2 PVC
Usage Guidelines
To use this command, you must ensure that the endpoint indicated by the endpt-num argument value has
been previously added, and that the associated DS0 is configured for CAS.
Note
To use this command, you must choose the MIB as the source in the cnfcasparamsource command.
Examples
The following example shows that endpoint 100 is configured with a CAS offhook time of 500 ms:
cnfcasoffhooktime 100 500
Related Commands
Command
dspcastimers
Cisco VISM Installation and Configuration Guide
5-102
cnfcasoffhooktime endpt-num offhooktime
The endpoint number which is to be configured with a guard time, identified by the
offhooktime argument value. It can be a value from one of the following ranges:
•
For template number 1:
For VISM, from 1 to 145
–
For VISM-PR T1, from 1 to 192
–
For VISM-PR E1, from 1 to 248
–
For template number 2:
•
–
For VISM T1, from 1 to 192
–
For VISM E1, from 1 to 248
•
For template number 3:
–
For VISM, from 1 to 120
–
For VISM-PR T1, from 1 to 192
For VISM-PR E1, from 1 to 248
–
For template number 4:
•
For VISM-PR, from 1 to 144
–
The off-hook time (defined in milliseconds); in the range from 10 to 1000.
Description
Displays an endpoint's currently configured CAS timers.
Chapter 5
Release 3.0, Part Number OL-2521-01 Rev. D0, June 2004
CLI Commands