Connecting The Ac Adapter; Connecting Target Cable To Pg-Fp3 <1 - NEC Flash Memory Programmer PG-FP3 User Manual

[Connecting the power supply]
With the power switch off, connect the AC adapter supplied as an accessory to the DC jack.
[Connecting the target]
Use the target cable supplied as an accessory to connect the target. Whether you use a Type 1 or Type 2 cable
depends on the specifications of the target. If the FA adapter
connect the target to the PG-FP3.
Note The FA adapter is a product of Naito Densei Machida Mfg. Co., Ltd.
When using a user target
Confirm that the target V
PG-FP3.
Connect the other end of the target cable to the user target (in the example below, an IC clip is used).
24
CHAPTER 2 CONFIGURATION
Photo 2-4. Connecting the AC Adapter
switch is set to the IN position and then connect one end of the target cable to the
DD
Photo 2-5. Connecting Target Cable to PG-FP3 <1>
User's Manual U13502EJ2V0UM00
Note
is used, either use a Type 2 cable, or directly