Table of Contents
Advertisement
Module Installation
The mA-3011 Embedded Host Module is designed for installation in AXIe Chassis that
meet AXIe-1 Revision 2.0, Base Architecture Specification. See section
Installation Procedure" on page 6-7
Verify Module Operation
The following procedure is intended to verify basic module operation. This procedure does
not verify that the module is operating within product specifications.
Operation Verification Procedure
1
Complete the Module Installation Procedure (see
page
2
Set up the mA-3011 as a host controller (see
page
3
Verify the mA-3011 Operating System (OS) is displayed on the monitor.
NOTE
The contents and appearance of the mA-3011's Operating System varies depending on
the operating system and software that has been installed on the module. Figure 3-1
shows an example of an mA-3011 with Red Hat version of Linux installed.
Figure 3-1
4
Verify you are able to navigate and access OS directories.
Rev. C0
April 2020
6-7).
3-4).
Example mA-3011 Operating System Display
mA-3011 AXIe Embedded Host Module Operation Guide
for module installation instructions.
"Module Installation Procedure" on
"Setup Module as Host Controller" on
Chapter 3 Setup and Installation
Upon Receipt
"Module
Page 3-3
Advertisement
Table of Contents
