Display Port Preference - 3Com 3CRWX120695A Command Reference Manual

display port
preference
Table 12 Output for display port poe (continued)
Field
Link status
Port type
PoE config
PoE Draw
See Also
"set port poe" on page 79
Displays the interface preferences set on WX4400 gigabit Ethernet ports.
Syntax —
display port preference [port-list]
— List of physical ports. MSS displays the preference for all
port-list
the specified ports.
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Usage — This command applies only to the WX4400.

display port preference

Description
Link status of the port:
up—The port is connected.
down—The port is not connected.
Port type:
MAP —The port is an MAP access port.
- (The port is not an MAP access port.)
PoE state:
enabled
disabled
Power draw on the port, in watts.
For 10/100 Ethernet ports on which PoE is disabled,
this field displays off. For gigabit Ethernet ports, this
field displays invalid, because PoE is not supported
on gigabit Ethernet ports.
The value overcurrent indicates a PoE problem such
as a short in the cable.
65