Set Service-Profile Wep Active-Unicast- Index; Set Service-Profile Wep Key-Index - 3Com 3CRWX120695A Command Reference Manual

set service-profile
wep active-unicast-
index
set service-profile
wep key-index
Specifies the static Wired-Equivalent Privacy (WEP) key (one of four) to
use for encrypting unicast frames.
Syntax —
set service-profile
name wep active-unicast-index num
— Service profile name.
name
— WEP key number. You can enter a value from 1 through 4.
num
Defaults — If WEP encryption is enabled and WEP keys are defined,
MAP radios use WEP key 1 to encrypt unicast frames, by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Before using this command, you must configure values for the
WEP keys you plan to use. Use the set service-profile wep key-index
command.
Examples — The following command configures service profile sp2 to
use WEP key 4 for encrypting unicast traffic:
WX4400# set service-profile sp2 wep active-unicast-index 4
success: change accepted.
See Also
"set service-profile wep active-multicast- index" on page 310
"set service-profile wep key-index" on page 311
Sets the value of one of four static Wired-Equivalent Privacy (WEP) keys
for static WEP encryption.
Syntax —
set service-profile name wep key-index num key value
— Service profile name.
name
— WEP key index. You can enter a value from 1
key-index num
through 4.
— Hexadecimal value of the key. You can enter a
key value
10-character ASCII string representing a 5-digit hexadecimal number
or a 26-character ASCII string representing a 13-digit hexadecimal

set service-profile wep active-unicast- index

311