Set Arp - 3Com 3CRWX120695A Command Reference Manual

WX1200# ping 10.1.1.1
PING 10.1.1.1 (10.1.1.1) from 10.9.4.34 : 56(84) bytes of data.
64 bytes from 10.1.1.1: icmp_seq=1 ttl=255 time=0.769 ms
64 bytes from 10.1.1.1: icmp_seq=2 ttl=255 time=0.628 ms
64 bytes from 10.1.1.1: icmp_seq=3 ttl=255 time=0.676 ms
64 bytes from 10.1.1.1: icmp_seq=4 ttl=255 time=0.619 ms
64 bytes from 10.1.1.1: icmp_seq=5 ttl=255 time=0.608 ms
--- 10.1.1.1 ping statistics ---
5 packets transmitted, 5 packets received, 0 errors, 0% packet loss

set arp

Examples — The following command pings a WX switch that has IP
address 10.1.1.1:
See Also
"traceroute" on page 159
Adds an ARP entry to the ARP table.
Syntax —
set arp {permanent | static | dynamic }
ip-addr mac-addr
— Adds a permanent entry. A permanent entry does not
permanent
age out and remains in the database even after a reboot, reset, or
power cycle.
— Adds a static entry. A static entry does not age out, but the
static
entry does not remain in the database after a reboot, reset, or power
cycle.
— Adds a dynamic entry. A dynamic entry is automatically
dynamic
removed if the entry ages out, or after a reboot, reset, or power cycle.
— IP address of the entry, in dotted decimal notation.
ip-addr
— MAC address to map to the IP address. Use colons to
mac-addr
separate the octets (for example, 00:11:22:aa:bb:cc).
Defaults — The default aging timeout is 1200 seconds.
Access — Enabled.
History— Introduced in MSS Version 3.0.
set arp 133