Display Dap Global - 3Com 3CRWX120695A Command Reference Manual

display dap global

The following command displays connection information specifically for a
Distributed MAP with serial ID M9DE48B6EAD00:
WX1200# display dap connection serial-id M9DE48B6EAD00
Total number of entries: 1
DAP Serial Id
--- -----------
9 M9DE48B6EAD00 10.10.4.88
Table 52 describes the fields in this display.
Table 52 Output of display dap connection
Field
DAP
Serial Id
DAP IP Address
WX IP Address
See Also
"display {ap | dap} config" on page 234
"display dap global" on page 251
"display dap unconfigured" on page 253
Displays configuration information for Distributed MAPs configured on
WX switches in the Mobility Domain.
Syntax —
display dap global [dap-num | serial-id serial-ID]
— Number of a Distributed MAP for which to display
dap-num
configuration settings.
serial-id serial-ID
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
DAP IP Address
--------------- ---------------
Description
Connection ID you assigned to the Distributed MAP.
If the connection is configured on another WX switch, this
field contains a hyphen ( - ).
Serial ID of the Distributed MAP.
IP address assigned by DHCP to the Distributed MAP.
System IP address of the WX switch on which the MAP has
an active connection. This is the switch that the MAP used
for booting and configuration and is using for data transfer.
— MAP access point serial ID.
display dap global
WX IP Address
10.9.9.11
251