Rmdir - 3Com 3CRWX120695A Command Reference Manual

rmdir

Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — If you do not use the force option, the command first
compares the running configuration to the configuration file. If the
running configuration and configuration file do not match, MSS does not
restart the WX switch but instead displays a message advising you to
either save the configuration changes or use the force option.
Examples — The following command restarts an WX switch that does
not have any unsaved configuration changes:
WX4400# reset system
This will reset the entire system. Are you sure (y/n)y
The following commands attempt to restart an WX switch with a running
configuration that has unsaved changes, and then force the switch to
restart:
WX4400# reset system
error: Cannot reset, due to unsaved configuration changes.
Use "reset system force" to override.
WX4400# reset system force
...... rebooting ......
See Also
"display boot" on page 469
"display version" on page 472
"save config" on page 478
Removes a subdirectory from nonvolatile storage.
Syntax —
rmdir [subdirname]
— Subdirectory name. Specify between 1 and 32
subdirname
alphanumeric characters, with no spaces.
Defaults — None.
Access — Enabled.
rmdir 477