3Com 3CRWX120695A Command Reference Manual page 256

256 C 9: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
Table 55 Output for display radio-profile (continued)
Field
Allow 802.11g
clients only
Tune Channel
Tune Power
Tune Channel
Interval
Tune Power Interval
Client Backoff Timer
Channel Holddown
Service profiles
Description
Indicates whether the 802.11b/g radios in the radio profile
restrict associations to 802.11g clients only:
No — 802.11b/g radios allow associations with both
802.11b and 802.11g clients.
No — 802.11b/g radios allow associations with 802.11g
clients only.
Note: This field applies only to 802.11b/g radios.
Indicates whether RF Auto-Tuning is enabled for dynamically
setting and tuning channels.
Indicates whether RF Auto-Tuning is enabled for dynamically
setting and tuning power levels.
Interval, in seconds, at which RF Auto-Tuning decides
whether to change the channels on radios in a radio profile.
At the end of each interval, MSS processes the results of the
RF scans performed during the previous interval, and
changes radio channels if needed.
Interval, in seconds, at which RF Auto-Tuning decides
whether to change the power level on radios in a radio
profile. At the end of each interval, MSS processes the results
of the RF scans performed during the previous interval, and
changes radio power levels if needed.
Interval, in minutes, at which radios in a radio profile reduce
power after temporarily increasing the power to maintain
the minimum data rate for an associated client. At the end of
each power-backoff interval, radios that temporarily
increased their power reduce it by 1 dBm. The power
backoff continues in 1 dBm increments after each interval
until the power returns to expected setting.
Minimum number of seconds a radio in a radio profile must
remain at its current channel assignment before
RF Auto-Tuning can change the channel.
Service profiles mapped to this radio profile. Each service
profile contains an SSID and encryption information for that
SSID.
Note: When you upgrade from 2.x, MSS creates a
default-dot1x service profile for encrypted SSIDs and a
default-clear service profile for unencrypted SSIDs. These
default service profiles contain the default encryption
settings for crypto SSIDs and clear SSIDs, respectively.