Set Rf Detect Countermeasures - 3Com 3CRWX120695A Command Reference Manual

set rf detect
countermeasures
for rogue devices by sending probe any requests (probe requests with a
null SSID name), to solicit probe responses from other access points.
Syntax —
set rfdetect active-scan {enable | disable}
— Enables active RF detection scanning.
enable
— Disables active RF detection scanning.
disable
Defaults — Active scanning is enabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You can enter this command on any WX switch in the Mobility
Domain. The command takes effect only on that switch.
Examples — The following command disables active scanning on a WX
switch:
WX1200# set rfdetect active-scan disable
success: off-channel scanning is disabled.
Enables or disables countermeasures for the Mobility Domain.
Countermeasures are packets sent by a radio to prevent clients from
being able to use a rogue access point.
CAUTION: Countermeasures affect wireless service on a radio. When a
MAP radio is sending countermeasures, the radio is disabled for use by
network traffic, until the radio finishes sending the countermeasures.
Syntax —
set rfdetect countermeasures {enable | disable}
— Enables countermeasures.
enable
— Disables countermeasures.
disable
Defaults — Countermeasures are disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command is valid only on the seed switch of the Mobility
Domain.

set rf detect countermeasures

459