Display Auto-Tune Neighbors - 3Com 3CRWX120695A Command Reference Manual

248 C 9: M
HAPTER ANAGED
display auto-tune
neighbors
A P C
CCESS OINT OMMANDS
"set {ap | dap} radio auto-tune max-power" on page 266
"set {ap | dap} radio auto-tune max- retransmissions" on page 267
"set radio-profile auto-tune channel-config" on page 276
"set radio-profile auto-tune channel-holddown" on page 277
"set radio-profile auto-tune channel-interval" on page 278
"set radio-profile auto-tune power-backoff- timer" on page 279
"set radio-profile auto-tune power-config" on page 280
"set radio-profile auto-tune power-interval" on page 281
Displays the other 3Com radios and third-party 802.11 radios that a
3Com radio can hear.
Syntax —

display auto-tune neighbors

[ap map-num [radio {1 | 2| all}]]
Syntax —
display auto-tune neighbors
[dap dap-num [radio {1 | 2| all}]]
— MAP port connected to the MAP access point for which to
map-num
display neighbors.
— Number of a Distributed MAP for which to display
dap-num
neighbors.
— Shows neighbor information for radio 1.
radio 1
— Shows neighbor information for radio 2. (This option does
radio 2
not apply to single-radio models.)
— Shows neighbor information for both radios.
radio all
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — For simplicity, this command displays a single entry for each
3Com radio, even if the radio is supporting multiple BSSIDs. However,
BSSIDs for third-party 802.11 radios are listed separately, even if a radio is
supporting more than one BSSID.