Clear Mobility-Domain Member - 3Com 3CRWX120695A Command Reference Manual

224 C 8: M
HAPTER OBILITY
clear
mobility-domain
member
D C
OMAIN OMMANDS
Syntax —
clear mobility-domain
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command has no effect if the WX switch is not configured
as part of a Mobility Domain.
Examples — To clear a Mobility Domain from a WX switch within the
domain, type the following command:
WX1200# clear mobility-domain
success: change accepted.
See Also
"clear mobility-domain member" on page 224
"set mobility-domain member" on page 226
"set mobility-domain mode member seed-ip" on page 227
"set mobility-domain mode seed domain-name" on page 228
On the seed WX switch, removes the identified member from the
Mobility Domain.
Syntax —
clear mobility-domain member ip-addr
— IP address of the Mobility Domain member, in dotted
ip-addr
decimal notation.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command has no effect if the WX switch member is not
configured as part of a Mobility Domain or the current WX switch is not
the seed.