Set Radius - 3Com 3CRWX120695A Command Reference Manual

set radius

To disable load balancing in a server group shorebirds, type the following
command:
WX4400# set server group shorebirds load-balance disable
success: change accepted.
See Also
"set server group" on page 411
Configures global defaults for RADIUS servers that do not explicitly set
these values themselves. By default, the WX switch automatically sets all
these values except the password (key).
Syntax —
set radius {deadtime minutes | key string |
retransmit number | timeout seconds}
deadtime minutes
declaring an unresponsive RADIUS server unavailable before retrying
the RADIUS server. You can specify from 0 to 1440 minutes.
— Password (shared secret key) used to authenticate to
key string
the RADIUS server. You must provide the same password that is
defined on the RADIUS server. The password can be 1 to 32 characters
long, with no spaces or tabs.
retransmit number
switch makes before declaring an unresponsive RADIUS server
unavailable. You can specify from 1 to 100 retries.
timeout seconds
RADIUS server to respond before retransmitting. You can specify from
1 to 65,535.
Defaults — Global RADIUS parameters have the following default
values:
deadtime — 0 (zero) minutes (The WX switch does not designate
unresponsive RADIUS servers as unavailable.)
key — No key
retransmit — 3 (the total number of attempts, including the first
attempt)
timeout — 5 seconds
Access — Enabled.
— Number of minutes the WX switch waits after
— Number of transmission attempts the WX
— Number of seconds the WX switch waits for the
set radius 407