Access Commands; Commands By Usage; Disable - 3Com 3CRWX120695A Command Reference Manual

2
Commands by
Usage

disable

Access Commands

This chapter describes access commands used to control access to the
Mobility Software System (MSS) command-line interface (CLI).
This chapter presents access services commands alphabetically. Use
Table 5 to located commands in this chapter based on their use.
Table 5 Access Commands by Usage
Type
Access Privileges
Changes the CLI session from enabled mode to restricted access.
Syntax —
disable
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command restricts access to the CLI for the
current session:
WX1200# disable
WX1200>
Command
"enable" on page 34
"set enablepass" on page 35
"disable" on page 33
"quit" on page 34