3Com 3CRWX120695A Command Reference Manual page 74

74 C 4: P
HAPTER ORT
C
OMMANDS
For a WX4400, you can specify a number from 1 to 256.
For a WX1200, you can specify a number from 1 to 30.
serial-id serial-ID
listed on the MAP case. To show the serial ID using the CLI, use the
display version details command.
The serial ID of the AP2750 might be preceded by 4 digits and a slash
(example: 0100/). Do not enter these digits or the slash.
model {ap2750
mp-262 | mp-341 | mp-352}
ap2750
software for 802.11a or 802.11b/g.
— Contains one 802.11a radio and one 802.11b radio,
mp-52
with adjustable external antennas.
mp-101
software for 802.11a or 802.11b.
mp-122
mp-241
software for 802.11a or 802.11b/g.
mp-252
mp-262
and a connector for an external antenna for the 802.11b/g radio.
mp-341
software for 802.11a or 802.11b/g, and a connector for an
external antenna for the 802.11b/g radio.
mp-352
and a connector for an external antenna for the 802.11b/g radio.
radiotype 11a | 11b| 11g
— 802.11a
11a
— 802.11b
11b
— 802.11g
11g
This option applies only to single-radio models. The value 11g does
not apply to model MP-101.
Defaults — The default radio type for model MP-101 is 802.11b. The
default radio type for model AP2750, MP-241, and MP-341, and for the
— MAP access point serial ID. The serial ID is
|
mp-52 | mp-101 | mp-122 | mp-241 | mp-252 |
— MAP access point model:
— Contains one radio that can be configured through
— Contains one radio that can be configured through
— Contains one 802.11a radio and one 802.11b/g radio.
— Contains one radio that can be configured through
— Contains one 802.11a radio and one 802.11b radio.
— Contains one 802.11a radio and one 802.11b radio,
— Contains one radio that can be configured through
— Contains one 802.11a radio and one 802.11b radio,
— Radio type: