Set Dot1X Port-Control - 3Com 3CRWX120695A Command Reference Manual

428 C 15: 802.1X M
HAPTER
set dot1x
port-control
C
ANAGEMENT OMMANDS
See Also
"clear dot1x max-req" on page 417
"display dot1x" on page 421
Determines the 802.1X authentication behavior on individual wired
authentication ports or groups of ports.
Syntax —

set dot1x port-control

{forceauth | forceunauth | auto} port-list
— Forces the specified wired authentication port(s) to
forceauth
unconditionally authorize all 802.1X authentication attempts, with an
EAP success message.
— Forces the specified wired authentication port(s) to
forceunauth
unconditionally reject all 802.1X authentication attempts with an EAP
failure message.
— Allows the specified wired authentication ports to process
auto
802.1X authentication normally as determined for the user by the set
authentication dot1X command.
— One or more wired authentication ports for which to
port-list
set 802.1X port control.
Defaults — By default, wired authentication ports are set to auto.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command affects only wired authentication ports.
Examples — The following command forces port 1 to unconditionally
accept all 802.1X authentication attempts:
WX4400# set dot1x port-control forceauth 1
success: authcontrol for 1 is set to FORCE-AUTH.
See Also
"display port status" on page 66
"display dot1x" on page 421