Set Vlan Port - 3Com 3CRWX120695A Command Reference Manual

104 C 5: VLAN C
HAPTER

set vlan port

OMMANDS
VLAN names are case-sensitive for RADIUS authorization when a client
roams to a wireless LAN switch. If the WX switch is not configured with
the VLAN the client is on, but is configured with a VLAN that has the
same spelling but different capitalization, authorization for the client fails.
For example, if the client is on VLAN red but the WX switch to which the
client roams has VLAN RED instead, RADIUS authorization fails.
Examples — The following command assigns the name marigold to
VLAN 3:
WX4400# set vlan 3 name marigold
success: change accepted.
See Also
"set vlan port" on page 104
Assigns one or more network ports to a VLAN. You also can add a virtual
port to each network port by adding a tag value to the network port.
Syntax —
set vlan vlan-id port port-list [tag tag-value]
— VLAN name or number.
vlan-id
port port-list
tag tag-value
specify a value from 1 through 4095.
By default, no ports are members of any VLANs. A wireless LAN switch
cannot forward traffic on the network until you configure VLANs and add
network ports to the VLANs.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You can combine this command with the set port name
command to assign the name and add the ports at the same time.
If you do not specify a tag value, the WX switch sends untagged frames
for the VLAN. If you do specify a tag value, the WX sends tagged frames
only for the VLAN.
— List of physical ports.
— Tag value that identifies a virtual port. You can