3Com 3CRWX120695A Command Reference Manual page 83

country-specific regulations on the WX switch. See "set system
countrycode" on page 51.
For an MAP that is indirectly connected to the WX switch through an
intermediate Layer 2 or Layer 3 network, use the set dap command to
configure a Distributed MAP.
Before changing the port type from ap to wired-auth or from
wired-auth to ap, you must reset the port with the clear port type
command.
Syntax —
set port type ap port-list model {ap2750 | mp-52 |
mp-101 | mp-122 | mp-241 | mp-252 | mp-262 | mp-341 | mp-352}
poe {enable | disable} [radiotype {11a | 11b | 11g}]
— List of physical ports.
port-list
model {ap2750 | mp-52 | mp-101 | mp-122 | mp-241 | mp-252 |
mp-262 | mp-341 | mp-352}
— Contains one radio that can be configured through
ap2750
software for 802.11a or 802.11b/g.
— Contains one 802.11a radio and one 802.11b radio, with
mp-52
adjustable external antennas.
— Contains one radio that can be configured through
mp-101
software for 802.11a or 802.11b.
— Contains one 802.11a radio and one 802.11b/g radio.
mp-122
— Contains one radio that can be configured through
mp-241
software for 802.11a or 802.11b/g.
— Contains one 802.11a radio and one 802.11b radio.
mp-252
— Contains one 802.11a radio and one 802.11b radio,
mp-262
and a connector for an external antenna for the 802.11b/g radio.
— Contains one radio that can be configured through
mp-341
software for 802.11a or 802.11b/g, and a connector for an
external antenna for the 802.11b/g radio.
— Contains one 802.11a radio and one 802.11b radio,
mp-352
and a connector for an external antenna for the 802.11b/g radio.
poe enable | disable
— MAP access point model:
— Power over Ethernet (PoE) state.
set port type ap 83