3Com 3CRWX120695A Command Reference Manual page 77

mode {on | off}
or off to disable the group. The group is enabled by default.
Defaults — Once configured, a group is enabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You can configure up to 8 ports in a port group, in any
combination of ports. The port numbers do not need to be contiguous
and you can use 10/100 Ethernet ports and gigabit Ethernet ports in the
same port group.
After you add a port to a port group, you cannot configure port
parameters on the individual port. Instead, change port parameters on
the entire group. Specify the group name instead of an individual port
name or number in port configuration commands.
To add or remove ports in a group that is already configured, change the
mode to off, add or remove the ports, then change the mode to on.
Examples — The following command configures a port group named
server1 containing ports 1 through 5, and enables the link:
WX1200# set port-group name server1 1-5 mode on
success: change accepted.
The following commands disable the link for port group server1, change
the list of ports in the group, and reenable the link:
WX1200# set port-group name server1 1-5 mode off
success: change accepted.
WX1200# set port-group name server1 1-4,7 mode on
success: change accepted.
See Also
"clear port-group" on page 59
"display port-group" on page 63
State of the group. Use on to enable the group
—
set port-group 77