Display Rfdetect Data - 3Com 3CRWX120695A Command Reference Manual

display rfdetect
data
Table 85 display rfdetect countermeasures Output
Field
Rogue MAC
Countermeasures
Radio MAC
WX-IPaddr
Port/Radio/Channel
See Also
"clear rfdetect countermeasures mac" on page 450
"set rf detect countermeasures" on page 459
"set rfdetect countermeasures mac" on page 460
Displays all the BSSIDs detected by an individual WX switch during an RF
detection scan. The data includes BSSIDs transmitted by other 3Com
radios as well as by third-party access points.
Syntax —

display rfdetect data

Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You can enter this command on any WX switch in the Mobility
Domain. The output applies only to the switch on which you enter the
command. To display all devices that a specific 3Com radio has detected,
even if the radio is managed by another WX switch, use the display
rfdetect visible command.
To display rogue information for the entire Mobility Domain, use the
display rfdetect mobility-domain command on the seed switch.
Description
BSSID of the rogue.
MAC address of the 3Com radio sending countermeasures
against the rogue.
If the field value is Not Started, MSS has not started
countermeasures against the rogue yet.
System IP address of the WX switch that is managing the
MAP that is sending or will send countermeasures.
Port number, radio number, and channel number of the
countermeasures radio. For a Distributed MAP, the
connection number is labeled dap. (This stands for
distributed ap.)
display rfdetect data 453