Set Igmp Oqi - 3Com 3CRWX120695A Command Reference Manual

set igmp oqi

Changes the IGMP other-querier-present interval timer on one VLAN or all
VLANs on a WX.
Syntax —
set igmp oqi seconds [vlan vlan-id]
— Number of seconds that the WX waits for a general
oqi seconds
query to arrive before electing itself the querier. You can specify a
value from 1 through 65,535.
— VLAN name or number. If you do not specify a
vlan vlan-id
VLAN, the timer change applies to all VLANs.
Defaults — The default other-querier-present interval is 255 seconds
(4.25 minutes).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — A WX cannot become the querier unless the pseudo-querier
feature is enabled on the WX switch. When the feature is enabled, the
WX becomes the querier for a subnet so long as the WX does not receive
a query message from a router with a lower IP address than the IP address
of the WX in that subnet. To enable the pseudo-querier feature, use set
igmp querier.
Examples — The following command changes the other-querier-present
interval on VLAN orange to 200 seconds:
WX1200# set igmp oqi 200 vlan orange
success: change accepted.
See Also
"set igmp lmqi" on page 356
"set igmp qi" on page 360
"set igmp qri" on page 361
"set igmp querier" on page 362
"set igmp mrouter" on page 356
"set igmp rv" on page 364
set igmp oqi 359