Set Radio-Profile Dtim-Interval; Set Radio-Profile Frag-Threshold - 3Com 3CRWX120695A Command Reference Manual

set radio-profile
dtim-interval
set radio-profile
frag-threshold
Changes the number of times after every beacon that each MAP radio in
a radio profile sends a delivery traffic indication map (DTIM). An MAP
access point sends the multicast and broadcast frames stored in its
buffers to clients who request them in response to the DTIM.
The DTIM interval applies to both the beaconed SSID and the
nonbeaconed SSID.
Syntax —
set radio-profile name dtim-interval interval
— Radio profile name.
name
— Number of times the DTIM is transmitted after every
interval
beacon. You can enter a value from 1 through 31.
Defaults — By default, MAP access points send the DTIM once after
each beacon.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command.
The DTIM interval does not apply to unicast frames.
Examples — The following command changes the DTIM interval for
radio profile rp1 to 2:
WX4400# set radio-profile rp1 dtim-interval 2
success: change accepted.
See Also
"display radio-profile" on page 254
"set radio-profile mode" on page 287
Changes the fragmentation threshold for the MAP radios in a radio
profile. The fragmentation threshold specifies the maximum length a
frame is allowed to be without being broken into multiple frames before
transmission.

set radio-profile dtim-interval

283