Set Spantree Uplinkfast - 3Com 3CRWX120695A Command Reference Manual

set spantree
uplinkfast
See Also
"display spantree" on page 320
Enables or disables STP uplink fast convergence on a wireless LAN switch.
This feature enables a WX switch with redundant links to the network
backbone to immediately switch to the backup link to the root bridge if
the primary link fails.
Syntax — set spantree uplinkfast {enable | disable}
enable — Enables uplink fast convergence.
disable — Disables uplink fast convergence.
Defaults — Disabled.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The uplink fast convergence feature is applicable to bridges
that are acting as access switches to the network core (distribution layer)
but are not in the core themselves. Do not enable the feature on WX
switches that are in the network core.
Examples — The following command enables uplink fast convergence:
WX4400# set spantree uplinkfast enable
success: change accepted.
See Also
"display spantree uplinkfast" on page 331

set spantree uplinkfast

341