Commands By Usage - 3Com 3CRWX120695A Command Reference Manual

17
Commands by
Usage
RF D
ETECTION
MSS automatically performs RF detection scans on enabled and disabled
radios to detect rogue access points. A rogue access point is a BSSID
(MAC address associated with an SSID) that does not belong to a 3Com
switch and is not a member of the ignore list configured on the seed
switch of the Mobility Domain. The ignore list is a list of third-party
(friendly) BSSIDs that are not rogues.
MSS can issue countermeasures against rogue devices to prevent clients
from being able to use them.
You can configure RF detection parameters only on the seed switch of a
Mobility Domain.
This chapter presents RF detection commands alphabetically. Use Table 84
to locate the commands in this chapter based on their use.
Table 84 RF Detection Commands by Usage
Type
Rogue Information "display rfdetect mobility-domain" on page 455
Countermeasures
C
OMMANDS
Command
"set rfdetect log" on page 462
"display rfdetect data" on page 453
"display rfdetect visible" on page 457
"set rf detect countermeasures" on page 459
"display rfdetect ignore" on page 455
"set rfdetect countermeasures mac" on page 460
"clear rfdetect countermeasures mac" on page 450