clear radius client
system-ip
clear radius server
See Also
"set radius" on page 407
"set radius server" on page 409
"display aaa" on page 180
Removes the WX switch's system IP address from use as the permanent
source address in RADIUS client requests from the switch to its RADIUS
server(s).
Syntax —
clear radius client system-ip
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — The clear radius client system-ip command causes the WX
switch to use the IP address of the interface through which it sends a
RADIUS client request as the source IP address. The WX switch selects a
source interface address based on information in its routing table as the
source address for RADIUS packets leaving the switch.
Examples — To clear the system IP address as the permanent source
address for RADIUS client requests, type the following command:
WX4400# clear radius client system-ip
success: change accepted.
See Also
"display aaa" on page 180
"set radius client system-ip" on page 408
Removes the named RADIUS server from the WX configuration.
Syntax —
clear radius server server-name
— Name of a RADIUS server configured to perform
server-name
remote AAA services for the WX switch.
clear radius client system-ip
405