Clear Radio-Profile - 3Com 3CRWX120695A Command Reference Manual

clear radio-profile

Removes the radio from its radio profile and places the radio in the
default radio profile.
This command does not affect the PoE setting.
Examples — The following command disables and resets radio 2 on the
MAP access point connected to port 3:
WX1200# clear ap 3 radio 2
See Also
"set {ap | dap} radio mode" on page 271
"set {ap | dap} radio radio-profile" on page 272
"set port type ap" on page 82
Removes a radio profile or resets one of the profile's parameters to its
default value.
Syntax —
clear radio-profile name [parameter]
— Radio profile name.
name
— Radio profile parameter:
parameter
beacon-interval
dtim-interval
frag-threshold
long-retry
max-rx-lifetime
max-tx-lifetime
preamble-length
rts-threshold
service-profile
short-retry
(For information about these parameters, see the set radio-profile
commands that use them.)
Defaults — If you reset an individual parameter, the parameter is
returned to the default value listed in Table 57 on page 287.
Access — Enabled.
clear radio-profile 233