3Com 3CRWX120695A Command Reference Manual page 152

152 C 6: IP S
HAPTER ERVICES
C
OMMANDS
Table 35 SNMP Trap Names (continued)
Name
MobilityDomainJoinTraps
MobilityDomainTimeoutTraps
MAPBootTraps
MAPTimeoutTraps
PoEFailTraps
RFDetectAdhocUserTraps
RFDetectRogueAPTraps
RFDetectRogueDisappearTraps
Default — All traps are disabled by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You can enable or disable the linkup and linkdown traps on an
individual port basis with the set port trap command. The individual port
setting overrides the global setting.
Examples — The following command disables all traps:
WX4400# set snmp trap disable all
success: change accepted.
The following command reenables authentication traps:
WX4400# set snmp trap enable AuthenTraps
success: change accepted.
See Also
"clear snmp trap receiver" on page 114
"display snmp configuration" on page 127
Description
Generated when the WX switch is initially
able to contact a mobility domain seed
member, or can contact the seed member
after a timeout.
Generated when a timeout occurs after a
radio device has unsuccessfully tried to
communicate with a seed member.
Generated when a MAP boots.
Generated when a MAP fails to respond to
the radio device.
Generated when a serious PoE problem,
such as a short circuit, occurs.
Generated when MSS detects an ad-hoc
user.
Generated when MSS detects a rogue access
point.
Generated when a rogue access point is no
longer being detected.