Set System Ip-Address - 3Com 3CRWX120695A Command Reference Manual

set system
ip-address
WX4400# set interface taupe ip 10.10.20.20/24
success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe
WX4400# set system ip-address 10.10.20.20
success: change accepted.
"display summertime" on page 129
"display timedate" on page 130
"display timezone" on page 131
"set timedate" on page 156
"set timezone" on page 157
Configures the system IP address. The system IP address determines the
interface or source IP address MSS uses for system tasks, including the
following:
Mobility domain operations
Topology reporting for dual-homed MAP access points
Default source IP address used in unsolicited communications such as
AAA accounting reports and SNMP traps
Syntax —
set system ip-address ip-addr
— IP address, in dotted decimal notation. The address must
ip-addr
be configured on one of the WX switch's VLANs.
Default — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You must use an address that is configured on one of the WX
switch's VLANs.
To display the system IP address, use the display system command.
Examples — The following commands configure an IP interface on
VLAN taupe and configure the interface to be the system IP address:

set system ip-address

155