Set Rfdetect Countermeasures Mac - 3Com 3CRWX120695A Command Reference Manual

460 C 17: RF D
HAPTER
set rfdetect
countermeasures
mac
C
ETECTION OMMANDS
Examples — The following command enables countermeasures for the
Mobility Domain managed by this seed switch:
WX1200# set rfdetect countermeasures enable
success: countermeasures are now enabled.
See Also
"clear rfdetect countermeasures mac" on page 450
"display rfdetect ignore" on page 455
"set rfdetect countermeasures mac" on page 460
Starts countermeasures against a specific rogue.
Syntax —
set rfdetect countermeasures mac mac-addr
— Basic service set identifier (BSSID) of the rogue. Enter the
mac-addr
BSSID in MAC address format, using a colon between each octet (for
example: aa:bb:cc:dd:ee:ff).
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Use this command to immediately begin countermeasures
against a specific rogue in the rogue list. The MAC address you specify
must be in the list of rogues generated by RF detection scans. MSS can
issue countermeasures only against a device that is in the rogue list.
You can start countermeasures against more than one BSSID by typing
additional set rfdetect countermeasures mac commands.
After you type the first set rfdetect countermeasures mac command,
MSS does not issue countermeasures against any devices except the ones
you specify using this command. To resume normal countermeasures
operation, where MSS automatically issues countermeasures against
detected rogues, use the clear rfdetect countermeasures mac all
command.
This command is valid only on the seed switch of the Mobility Domain.
The countermeasures take effect only if countermeasures are enabled for