Set Rfdetect Ignore - 3Com 3CRWX120695A Command Reference Manual

set rfdetect ignore

the Mobility Domain, using the set rfdetect countermeasures enable
command.
This command does not become part of the configuration file when you
save the configuration and therefore is not reloaded if the switch is
restarted.
Examples — The following command begins countermeasures against
rogue BSSID aa:bb:cc:11:22:33:
WX1200# set rfdetect countermeasures mac aa:bb:cc:11:22:33
success: set rfdetect countermeasures mac aa:bb:cc:11:22:33
See Also
"clear rfdetect countermeasures mac" on page 450
"display rfdetect ignore" on page 455
"set rf detect countermeasures" on page 459
Configures a list of known devices to ignore during an RF scan. MSS does
not generate log messages or traps for the devices in the ignore list.
Syntax —
set rfdetect ignore mac-addr
— BSSID (MAC address) of the device to ignore.
mac-addr
Defaults — MSS reports all unknown BSSIDs detected during an RF scan.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — Use this command to identify third-party APs and other devices
you are already aware of and do not want MSS to report following RF
scans.
If you try to initiate countermeasures against a device on the ignore list,
the ignore list takes precedence and MSS does not issue the
countermeasures. Countermeasures apply only to rogue devices.
set rfdetect ignore 461