Map Access Point Commands By Usage - 3Com 3CRWX120695A Command Reference Manual

9
MAP Access Point
Commands by
Usage
M
ANAGED
C
OMMANDS
Use MAP access point commands to configure and manage MAP access
points. Be sure to do the following before using the commands:
Define the country-specific IEEE 802.11 regulations on the WX switch.
(See "set system countrycode" on page 51.)
Install the MAP access point and connect it to a port on the WX
switch.
Configure a MAP access port (for a directly connected MAP) or a
Distributed MAP. (See "set port type ap" on page 82 and "set dap"
on page 73.)
CAUTION: Changing the system country code after MAP configuration
disables MAP access points and deletes their configuration. If you change
the country code on a WX switch, you must reconfigure all MAP access
points.
This chapter presents MAP access point commands alphabetically. Use
Table 43 to locate commands in this chapter based on their use.
Table 43 Map Access Point Commands by Usage
Type
External Antenna
Radio Profile
Assignment
SSID Assignment
A
CCESS
Command
"set {ap | dap} radio antennatype" on page 265
"set {ap | dap} radio radio-profile" on page 272
"set radio-profile mode" on page 287
"clear radio-profile" on page 233
"set radio-profile service-profile" on page 291
"display radio-profile" on page 254
"set service-profile ssid-name" on page 307
P
OINT