Set Interface - 3Com 3CRWX120695A Command Reference Manual

set interface

WX1200# set interface default ip 10.10.10.10/24
success: set ip address 10.10.10.10 netmask 255.255.255.0 on vlan default
WX1200# set interface mauve ip 10.10.20.10 255.255.255.0
success: set ip address 10.10.20.10 netmask 255.255.255.0 on vlan mauve
Configures an IP interface on a VLAN.
Syntax —
set interface
{ip-addr mask | ip-addr/mask-length}
— VLAN name or number.
vlan-id
— IP address and subnet mask in dotted decimal
ip-addr mask
notation (for example, 10.10.10.10 255.255.255.0).
ip-addr/mask-length
format (for example, 10.10.10.10/24).
Defaults — None.
Access — Enabled.
History— Introduced in MSS Version 3.0.
Usage — You can assign one IP interface to each VLAN.
If an interface is already configured on the VLAN you specify, this
command replaces the interface. If you replace an interface that is in use
as the system IP address, replacing the interface can interfere with system
tasks that use the system IP address, including the following:
Mobility domain operations
Topology reporting for dual-homed MAP access points
Default source IP address used in unsolicited communications such as
AAA accounting reports and SNMP traps
Examples — The following command configures IP interface
10.10.10.10/24 on VLAN default:
The following command configures IP interface 10.10.20.10
255.255.255.0 on VLAN mauve:
vlan-id ip
— IP address and subnet mask length in CIDR
set interface 135