Display Rfdetect Visible - 3Com 3CRWX120695A Command Reference Manual

display rfdetect
visible
See Also
"display rfdetect data" on page 453
"display rfdetect visible" on page 457
Displays the BSSIDs discovered by a specific 3Com radio. The data
includes BSSIDs transmitted by other 3Com radios as well as by
third-party access points.
Syntax —
display rfdetect visible mac-addr
Syntax —
display rfdetect visible ap map-num [radio {1 | 2}]
Syntax —
display rfdetect visible dap
dap-num [radio {1 | 2}]
— Base MAC address of the 3Com radio.
mac-addr
To display the base MAC address of a 3Com radio, use the
display {ap | dap} status command.
— Port connected to the MAP access point for which to
map-num
display neighboring BSSIDs.
— Number of a Distributed MAP for which to display
dap-num
neighboring BSSIDs.
— Shows neighbor information for radio 1.
radio 1
— Shows neighbor information for radio 2. (This option does
radio 2
not apply to single-radio models.)
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — If a 3Com radio is supporting more than one SSID, each of the
corresponding BSSIDs is listed separately.
To display rogue information for the entire Mobility Domain, use the
display rfdetect mobility-domain command on the seed switch.

display rfdetect visible

457