Set Snmp Trap - 3Com 3CRWX120695A Command Reference Manual

150 C 6: IP S
HAPTER

set snmp trap

C
ERVICES OMMANDS
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — SNMP community strings are passed as clear text. 3Com
recommends that you use strings that cannot easily be guessed by
unauthorized users.
Examples — The following command configures the read-write
community good_community:
WX4400# set snmp community read-write good_community
success: change accepted.
See Also
"clear snmp trap receiver" on page 114
"display snmp configuration" on page 127
"set ip snmp server" on page 142
"set snmp trap" on page 150
"set snmp trap receiver" on page 153
Enables or disables the SNMP trap capability. Traps are event notifications.
When a trap condition occurs, the wireless LAN switch sends an SNMP
trap message to any network management system specified as a trap
receiver.
Syntax —
set snmp trap
— Enables trap information to be sent.
enable
— Disables the sending of trap information.
disable
— Enables or disables all traps.
all
trap-name
{
enable
— Any of the items in Table 35.
| } [ |
disable all trap-name
]