3Com 3CRWX120695A Command Reference Manual page 274

274 C 9: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
tx-power power-level
1 milliwatt (dBm). The valid values depend on the country of
operation.
The maximum transmit power you can configure on any 3Com radio
is the maximum allowed for the country in which you plan to operate
the radio or one of the following values if that value is less than the
country maximum: on an 802.11a radio, 11 dBm for channel numbers
less than or equal to 64, or 10 dBm for channel numbers greater than
64; on an 802.11b/g radio, 16 dBm for all valid channel numbers for
802.11b, or 14 dBm for all valid channel numbers for 802.11g.
Defaults — The default transmit power on all MAP radio types is the
highest setting allowed for the country of operation or highest setting
supported on the hardware, whichever is lower.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You also can configure a radio's channel on the same
command line. Use the channel option.
This command is not valid if dynamic power tuning (RF Auto-Tuning) is
enabled.
Examples — The following command configures the transmit power on
the 802.11a radio on the MAP access point connected to port 5:
WX1200# set ap 5 radio 1 tx-power 10
success: change accepted.
The following command configures the channel and transmit power on
the 802.11b/g radio on the MAP access point connected to port 1:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
"display {ap | dap} config" on page 234
"set {ap | dap} radio channel" on page 269
— Number of decibels in relation to