Display Config - 3Com 3CRWX120695A Command Reference Manual

470 C 18: F
HAPTER ILE

display config

M C
ANAGEMENT OMMANDS
Table 91 describes the fields in the display boot output.
Table 91 Output for display boot
Field
Configured boot
image
Configured boot
configuration
Booted version
Booted image
Booted configuration Configuration filename MSS used to load the configuration
See Also
"clear boot config" on page 463
"display version" on page 472
"reset system" on page 476
"set boot configuration-file" on page 479
Displays the configuration running on the WX switch.
Syntax —
display config [area area] [all]
— Configuration area. You can specify one of the
area area
following:
aaa
acls
ap
arp
eapol
httpd
ip
ip-config
log
mobility-domain
Description
Boot partition and image filename MSS will use to boot next
time the software is rebooted.
Configuration filename MSS will use to boot next time the
software is rebooted.
Software version the switch is running.
Boot partition and image filename MSS used the last time
the software was rebooted. MSS is running this software
image.
the last time the software was rebooted.