3Com 3CRWX120695A Command Reference Manual page 43

===============================================================================
Fan status: fan1 OK fan2 OK fan3 OK
Temperature: temp1 ok
PSU Status: Lower Power Supply DC ok AC ok
Memory: 97.04/744.03 (13%)
Total Power Over Ethernet : 29.000
===============================================================================
temp2 ok temp3 ok
Table 7 describes the fields of display system output.
Table 7 display system output
Field
Product Name
System Name
System Countrycode
System Location
System Contact
System IP
System MAC
License
Boot Time
Uptime
Fan status
Upper Power Supply missing
Description
Switch model number.
System name (factory default, or optionally configured
with set system name).
Country-specific 802.11 code required for MAP operation
(configured with set system countrycode).
Record of the WX switch's physical location (optionally
configured with set system location).
Contact information about the system administrator or
another person to contact about the system (optionally
configured with set system contact).
Common interface, source, and default IP address for the
device, in dotted decimal notation (configured with set
system ip-address).
WX switch's media access control (MAC) machine address
set at the factory, in 6-byte hexadecimal format.
License level installed on the WX switch (if applicable).
Date and time of the last system reboot.
Number of days, hours, minutes, and seconds that the WX
has been operating since its last restart.
Operating status of the WX switch's three cooling fans:
OK — Fan is operating.
Failed — Fan is not operating. MSS sends an alert to
the system log every 5 minutes until this condition is
corrected.
Fan 1 is located nearest the front of the chassis, and fan 3
is located nearest the back.
display system 43