3Com 3CRWX120695A Command Reference Manual page 235

WX1200# display ap config 2
Port 1: AP model: AP2750, POE:
boot-download-enable: YES
load balancing group: none
Radio 1: type: 802.11g, mode:
tx pwr: dynamic, profile: default
auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10
WX4400# display dap config 1
Dap 1: Serial-Id: M9DE48B012F00, MAP model: AP2750, bias: high, name: DAP1
boot-download-enable: YES
Radio 1: type: 802.11a, mode: disabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Usage — MSS lists information separately for each MAP access point.
Examples — The following example shows configuration information for
an MAP access point on WX port 2:
enable, bias: high, name: MAP01
enabled, channel: dynamic
The following example shows configuration information for a Distributed
MAP access point configured on connection 1:
Table 45 describes the fields in this display.
Table 45 Output for display ap config
Field
Port
DAP
Serial-Id
Description
WX port number.
Note: This field is applicable only if the MAP is directly
connected to the WX switch and the WX switch's port is
configured as a MAP access port.
Connection ID for the Distributed MAP.
Note: This field is applicable only if the MAP is configured on
the WX switch as a Distributed MAP.
Serial ID of the MAP access point.
Note: This field is displayed only for Distributed MAPs.
display {ap | dap} config 235