Set {Ap | Dap} Radio Radio-Profile - 3Com 3CRWX120695A Command Reference Manual

272 C 9: M
HAPTER ANAGED
set {ap | dap} radio
radio-profile
A P C
CCESS OINT OMMANDS
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — To enable or disable one or more radios to which a profile is
assigned, use the set ap radio radio-profile command. To enable or
disable all radios that use a specific radio profile, use the set
radio-profile command.
Examples — The following command enables radio 1 on the MAP access
points connected to ports 1 through 5:
WX1200# set ap 1-5 radio 1 mode enable
success: change accepted.
The following command enables radio 2 on ports 1 through 3:
WX1200# set ap 1-3 radio 2 mode enable
success: change accepted.
See Also
"clear {ap | dap} radio" on page 232
"display {ap | dap} config" on page 234
"set {ap | dap} radio radio-profile" on page 272
"set radio-profile mode" on page 287
Assigns a radio profile to an MAP radio and enables or disables the radio.
Syntax —
set {ap port-list | dap dap-num} radio {1 | 2}
radio-profile name mode {enable | disable}
— List of ports.
ap port-list
— Number of a Distributed MAP.
dap dap-num
— Radio 1 of the MAP.
radio 1
— Radio 2 of the MAP. (This option does not apply to
radio 2
single-radio models.)
radio-profile name
characters, with no spaces.
— Enables radios on the specified ports with the
mode enable
parameter settings in the specified radio profile.
— Radio profile name of up to 16 alphanumeric