Set Spantree - 3Com 3CRWX120695A Command Reference Manual

332 C 10: STP C
HAPTER
WX4400# display spantree uplinkfast
VLAN port
------------------------------------------------------------------------
1 1(fwd),2,3

set spantree

OMMANDS
Examples — The following command shows uplink fast convergence
information for all VLANs:
list
Table 63 describes the fields in this display.
Table 63 Output for display spantree uplinkfast
Field
VLAN
port list
See Also
"set spantree uplinkfast" on page 341
Enables or disables STP on one VLAN or all VLANs configured on a WX
switch.
Syntax —
set spantree {enable | disable }
[{all | vlan vlan-id | port port-list vlan-id}]
— Enables STP.
enable
— Disables STP.
disable
— Enables or disables STP on all VLANs.
all
vlan vlan-id
on only the specified VLAN, on all ports within the VLAN.
port port-list vlan-id
ports are in. MSS enables or disables STP on only the specified ports,
within the specified VLAN.
Defaults — Disabled.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Description
VLAN number.
Ports in the uplink group. The port that is forwarding
traffic is indicated by fwd. The other ports are blocking
traffic.
— VLAN name or number. MSS enables or disables STP
— Port number or list and the VLAN the