Set {Ap | Dap} Radio Min-Client-Rate - 3Com 3CRWX120695A Command Reference Manual

270 C 9: M
HAPTER ANAGED
set {ap | dap} radio
min-client-rate
A P C
CCESS OINT OMMANDS
See Also
"display {ap | dap} config" on page 234
"set {ap | dap} radio tx-power" on page 273
Sets the minimum rate at which a radio is allowed to transmit traffic to
clients. The radio automatically increases its transmit power when
necessary to maintain at least the minimum rate with an associated client.
Syntax —
set {ap port-list | dap dap-num } radio {1 | 2}
auto-tune min-client-rate rate
— List of ports connected to the MAP access points on
ap port-list
which to set the channel.
— Number of a Distributed MAP on which to set the
dap dap-num
channel.
— Radio 1 of the MAP.
radio 1
— Radio 2 of the MAP. (This option does not apply to
radio 2
single-radio models.)
— Minimum data rate, in megabits per second (Mbps). The valid
rate
values depend on the radio type:
For 802.11g radios—54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, or 1
For 802.11b radios—11, 5.5, 2, or 1
For 802.11a radios—54, 48, 36, 24, 18, 12, 9, or 6
Defaults — The default minimum data transmit rate depends on the
radio type:
The default minimum data rate for 802.11b/g and 802.11b radios is
5.5 Mbps.
The default minimum data rate for 802.11a radios is 24 Mbps.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — If the data rate for traffic sent by a radio to an associated client
falls below the default minimum rate, the radio increases power, in
1 dBm increments, until all clients are at or above the minimum rate.