3Com 3CRWX120695A Command Reference Manual page 44

44 C 3: S
HAPTER YSTEM
S C
ERVICE OMMANDS
Table 7 display system output (continued)
Field
Temperature
PSU Status
Memory
Total Power Over
Ethernet
See Also
"clear system" on page 39
"set system contact" on page 51
"set system countrycode" on page 51
"set system ip-address" on page 53
"set system location" on page 54
"set system name" on page 55
Description
Status of temperature sensors at three locations in the WX
switch:
ok — Temperature is within the acceptable range of
0° C to 50° C (32° F to 122° F).
Alarm — Temperature is above or below the
acceptable range. MSS sends an alert to the system log
every 5 minutes until this condition is corrected.
Status of the lower and upper power supply units:
missing — Power supply is not installed or is
inoperable.
DC ok — Power supply is producing DC power.
DC output failure — Power supply is not producing
DC power. MSS sends an alert to the system log every
5 minutes until this condition is corrected.
AC ok — Power supply is receiving AC power.
AC not present — Power supply is not receiving AC
power.
Current size (in megabytes) of nonvolatile memory
(NVRAM) and synchronous dynamic RAM (SDRAM), plus
the percentage of total memory space in use, in the
following format:
NVRAM size /SDRAM size (percent of total)
Total power that the device is currently supplying to its
directly connected MAP access points, in watts.