Set Radius Server - 3Com 3CRWX120695A Command Reference Manual

set radius server

Examples — The following command sets the WX system IP address as
the address of the RADIUS client:
WX4400# set radius client system-ip
success: change accepted.
See Also
"clear radius client system-ip" on page 405
"set system ip-address" on page 53
Configures RADIUS servers and their parameters. By default, the WX
switch automatically sets all these values except the password (key).
Syntax —
set radius server
[address ip-address] [auth-port port-number] [acct-port
port-number] [timeout seconds] [retransmit number] [deadtime
minutes] [key string] [author-password password]
— Unique name for this RADIUS server. Enter an
server-name
alphanumeric string of up to 32 characters, with no blanks.
address ip-address
address in dotted decimal notation.
auth-port port-number
authentication and authorization.
acct-port port-numbe
accounting.
timeout seconds
RADIUS server to respond before retransmitting. You can specify from
1 to 65,535 seconds.
retransmit number
before declaring an unresponsive RADIUS server unavailable. You can
specify from 1 to 100 retries.
deadtime minutes
declaring an unresponsive RADIUS server unavailable before retrying
that RADIUS server. Specify between 0 (zero) and 1440 minutes
(24 hours). A zero value causes the switch to identify unresponsive
servers as available.
server-name
— IP address of the RADIUS server. Enter the
— UDP port that the WX switch uses for
r — UDP port that the WX switch uses for
— Number of seconds the WX switch waits for the
— Number of transmission attempts made
— Number of minutes the WX switch waits after
set radius server 409