Set Fdb Agingtime - 3Com 3CRWX120695A Command Reference Manual

102 C 5: VLAN C
HAPTER

set fdb agingtime

OMMANDS
vlan vlan-id
member. The entry is added only for the specified VLAN.
tag tag-value
can specify a number from 1 through 4095. If you do not specify a tag
value, an entry is created for an untagged interface only. If you specify
a tag value, an entry is created only for the specified tagged interface.
Default — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You cannot add a multicast or broadcast address as a
permanent or static FDB entry.
Examples — The following command adds a permanent entry for MAC
address 00:11:22:aa:bb:cc on ports 3 and 5 in VLAN blue:
WX1200# set fdb perm 00:11:22:aa:bb:cc port 3,5 vlan blue
success: change accepted.
The following command adds a static entry for MAC address
00:2b:3c:4d:5e:6f on port 1 in the default VLAN:
WX4400# set fdb static 00:2b:3c:4d:5e:6f port 1 vlan default
success: change accepted.
See Also
"clear fdb" on page 90
"display fdb" on page 92
Changes the aging timeout period for dynamic entries in the forwarding
database.
Syntax —
set fdb agingtime vlan-id age seconds
— VLAN name or number. The timeout period change
vlan-id
applies only to entries that match the specified VLAN.
— Value for the timeout period, in seconds. You can
age seconds
specify a value from 0 through 1,000,000. If you change the timeout
period to 0, aging is disabled.
— Name or number of a VLAN of which the port is a
— VLAN tag value that identifies a virtual port. You