362
C
11: IGMP S
HAPTER
set igmp querier
C
NOOPING
OMMANDS
History — Introduced in MSS Version 3.0.
Usage — The query response interval is applicable only when the WX is
querier for the subnet. For the WX to become the querier, the
pseudo-querier feature must be enabled on the WX and the WX must
have the lowest IP address among all the WX switches eligible to become
a querier. To enable the pseudo-querier feature, use set igmp querier.
Examples — The following command changes the query response
interval on VLAN orange to 50 tenths of a second (5 seconds):
WX1200# set igmp qri 50 vlan orange
success: change accepted.
See Also
"set igmp lmqi" on page 356
"set igmp oqi" on page 359
"set igmp qi" on page 360
"set igmp querier" on page 362
"set igmp rv" on page 364
Enables or disables the IGMP pseudo-querier on a WX, on one VLAN or
all VLANs.
Syntax —
set igmp querier {enable | disable} [vlan vlan-id]
— Enables the pseudo-querier.
enable
— Disables the pseudo-querier.
disable
vlan vlan-id
VLAN, the pseudo-querier is enabled or disabled on all VLANs.
Defaults — The pseudo-querier is disabled on all VLANs by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — 3Com recommends that you use the pseudo-querier only when
the VLAN contains local multicast traffic sources and no multicast router
is servicing the subnet.
— VLAN name or number. If you do not specify a
Need help?
Do you have a question about the 3CRWX120695A and is the answer not in the manual?